Fass T UIM 260G User Manual

INSTALLATION MANUALAPPLICATION:T UIM 260G (260gph @ 16psi)Unit Injected Mechanical Engines *Requires a Fuel Line Kit*

Some of the photo’s are of a different application, procedures are the same. C. Attach BR-2001 to back of system using the spacers and 1/4” bolts.

A. Fuel lines, excluding nylon type fuel lines, in excess of 6 years old should be replaced due to interior lining deterioration. This condition

A. Locate extra bung on the fuel tanks, most KW’s have a 1/4”, Peterbilt have 3/8” or 1/2” extra pipe plug located by the fuel lines a

C. Assemble the “T” using (1) 3/8 NPT ‘T’, (2) -8 ANx3/8 MPT & (1) -8 ANx3/8 MPT 90° as seen in the photo. J. In the same manner as previously

B. Install –8 AN hydraulic fitting into fuel line using the following procedures: refer to this procedure when necessary. B2. Secure female end in

C. Attach the line completed in Step 4b to the return port of the FASS labeled with an “R”. Route to the port in the fuel tank being us

A. Attach the fuel supply line from the fuel tank to the FASS using a 10-273L or one of the fitting from the filter housing removed in step 2. IF f

B. Secure female end in vise. D. The male portion should tightened all the way, as seen. A. Assemble fuel line into female hose fitting (reverse

L. In the same manner as previously covered, route and loosely connect the assembled fuel lines discussed in this section to the appropriate points

Fuel Tank Vent Line Fuel Tank FASS Return N. Locate Fuel Tank Vent Line and remove vent and vent line from tank. Thread tape reducer on both end

Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+

A. Bolts and fasteners properly tightened? B. Electrical harness and fuel lines secured and properly tightened? C. Has the system been primed, re

Fuel Filter –Install FWS-3003 on side of pump with draw tube in the middle of the filter nipple. Water Separator Filter –Install FS-1001 on water s

Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep

FASS Recommended Application T UIM 260G Class 1– Class 8, Agriculture, Industrial, Recreational, Hwy and off-road. Applications requiring fuel flo

(T UIM 260G) (T UIM 260G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS TITANIUM

Titanium Series 260 GPH 16 PSI (Approximately) A fuel pressure gauge is highly recommended to identify fuel filter life and to prevent engine dama

Contents WH-1005 BR-2001 MP-9050 *WE-1001* 78143 Oil Pressure Switch

Mounting Package Contents Mounting template RS-1001 RS-2684 Spade Terminal Ring Terminal 10-273 4 Locking Nut 3/8” 3 WA-1001D 4 3/8-16

The installation of the electrical harness is done first, allowing power to be applied to the pump for lubrication purposes. C. Connect WE-1001 wi

A. Remove primary fuel and/or water separator. If primary filter is part of the fuel pump, ignore this step. B. Skip this step if primary filter i