Fass T 080G User Manual

INSTALLATION MANUALAPPLICATION:T 080G (80gph @ 60psi)CLASS 1-CLASS 8 *Requires a Fuel Line Kit*

Some of the photo’s are of a different application, procedures are the same. D. Position system where it will be mounted. Mark the (4) mounti

A. Fuel lines, excluding nylon type fuel lines, in excess of 6 years old should be replaced due to interior lining deterioration. This condition

A. Locate extra bung on the fuel tanks, most KW’s have a 1/4”, Peterbilt have 3/8” or 1/2” extra pipe plug located by the fuel lines a

C. Assemble the “T” using (1) 3/8 NPT ‘T’, (2) -8 ANx3/8 MPT & (1) -8 ANx3/8 MPT 90° as seen in the photo. J. In the same manner as previously

B. Install –8 AN hydraulic fitting into fuel line using the following procedures: refer to this procedure when necessary. B2. Secure female end in

C. Attach the line completed in Step 4b to the return port of the FASS labeled with an “R”. Route to the port in the fuel tank being u

A. Attach the fuel supply line from the fuel tank to the FASS using a 10-273L or one of the fitting from the filter housing removed in step 2. IF f

B. Secure female end in vise. D. The male portion should tightened all the way, as seen. A. Assemble fuel line into female hose fitting (reverse

L. In the same manner as previously covered, route and loosely connect the assembled fuel lines discussed in this section to the appropriate points

Fuel Tank Vent Line Fuel Tank FASS Return N. Locate Fuel Tank Vent Line and remove vent and vent line from tank. Thread tape reducer on both end

Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of

A. Bolts and fasteners properly tightened? B. Electrical harness and fuel lines secured and properly tightened? C. Has the system been primed, re

Fuel Filter –Install FWS-3003 on side of pump with draw tube in the middle of the filter nipple. Water Separator Filter –Install FS-1001 on water s

Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep

FASS Recommended Application T 080G Class 1– Class 8, Agriculture, Industrial, Recreational, Hwy and off-road. Applications requiring fuel flow de

(T 080G) (T 080G) Serial # Found INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS T

Titanium Duty Series 80 GPH 60 PSI (Approximately) A fuel pressure gauge is highly recommended to identify fuel filter life and to prevent engine

Contents WH-1005 BR-2001 MP-9050 *WE-1001*

Mounting Package Contents Mounting template RS-1001 RS-2684 Spade Terminal 4 Locking Nut 3/8” Ring Terminal 3 WA-1001D 4 3/8-16”x 1 1/

A. Select best location in firewall for passage of wiring harness from cab to engine compartment. B. Find or drill a 7/8” hole in firewall. Instal

A. Remove primary fuel and/or water separator. If primary filter is part of the fuel pump, ignore this step. B. Skip this step if primary filter i