Fass T F14 220G User Manual Page 1

INSTALLATION MANUALAPPLICATION:T F14 220G (220gph @ 55psi)Powerstroke 7.3L*Bypassing the Factory Lift Pump*1999-2003Powerstroke 6.0L*Bypassing the Fac

O. Push one end of 1/2” fuel line onto ‘R’ port of suction tube assy. & one end of the 5/8” onto the ‘S’ port. Loop fuel line over frame. Do

A. Using thread tape, install the 10-300 into “E” and the 10-302 into the “T” port (on opposite end). Torque to 40 lb./ft.² Note:

D. Secure PFB-2002 and RS-2001 with (1) hex bolt 1/2” -20 x 1 1/2” and (1) 1/2” washer to PFB-2002C C. Insert PFB-2002C in to bed channel align

F. Cut off the power lead terminal. Using appropriate tools, crimp the Butt Splice to the factory power lead and the WE-1001. Shrink blue cover wit

H. Position the PBR-2001 to the PFB-2002 pump assembly at the mounting location and check for fit. J. Once secure use 3-1 3/4 bolts and

K. Apply motor oil to gasket located on filters. Attach to system and hand tighten. Fuel Filter –Install FWS-3003 on side of pump with dr

Caution: Do Not use sealant on AN fittings. Only use sealant on threads installed into pump assembly. C. Insert PL-1005 into remaining fuel line u

F. Bypass factory fuel pump. G. Using a quick disconnect tool, remove the outlet side of the factory fuel pump. The factory return line on th

G. Route the fuel line from the “E” port of the FASS to the factory lift pump’s outlet quick disconnect and cut to length. Insert the PLB

Note: The Red Plastic Plugs located in the “H” ports can stay in place fuel will not flow through these ports. Coolant can be plumbed into these po

Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of

Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep

Serial # FASS Recommended Application T F14 220G Powerstroke 1999-2007 with super extreme horsepower modifications ¡WARNINGs!  Read all instru

(T F14 220G) (T F14 220G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS TITANIUM

Titanium Series 220 GPH 50 PSI (Approximately) Installation Step 1: Install Electrical Harness Step 2: Prepare Suction and Return Lines Step 3

WH-1005 MP-9045 FL-1002 x14’ Contents PFB-2001C PFB-2002 PBR-2001 FL-1058 x3’

*WE-1001* Mounting Package Contents 10-302 Butt Splice Ring Terminal PL-1004 ST-1005Px16” BHN-1001 LW-1001 BHF-1002 PL-1005 OR-223 10-300 PLB-12516

A. Using ring terminals, attach red wire of the WH-1005 to the positive battery terminal. Attach green wire to a clean ground, preferably the negat

E. With the fuel tank empty of fuel, remove it from the vehicle. F. Clean the fuel module area then remove the lock ring on the top of the fuel ta