Fass FA F16 220G User Manual Page 1

INSTALLATION MANUALAPPLICATION:FA F16 220G (220G @ 8psi)Ford Powerstroke 6.4L*bypassing the factory Lift Pump*2008-2010

M. Carefully reinstall install pick up module making sure the leveling arm is not obstructed by the suction tube. Reinstall factory lock ring. Push

Some of the photo’s are of a different application, procedures are the same. A. Insert PFB-2001C in to bed channel align the nut with the opening

E. Slid the FASS pump into mounting brackets with the weep hole facing down. Torque (4) bolts to 110 inch pounds. D. Using thread tape, install t

VERY IMPORTANT: REMEMBERING THE POSITION OF THE “T” PORT, THERE IS A SMALL WEEP HOLE IN THE BASE DIRECTLY NEXT TO THE ELECTRIC MOTOR,

A. Using quick disconnect tools, remove the fuel lines from the front of the factory HFCM lift pump. Re-move the fuel lines attached to the rear of

The preset pressure is approximately 8 psi. Follow these steps to check or reset the fuel pressure. The port with 1/8” Allen plug marked with the le

Disclaimer: To help insure you receive the proper system and customer support at the local level, FASS has a VIP and Authorized Dealer network rep

Dear Valued Customer, “Made in the USA” is not just a slogan at FASS; it’s what we live by! FASS is not only assembled in the USA but 98%+ of

FASS Recommended Application FA F16 220G Powerstroke (6.4L) 2008 - 2010 with super extreme horsepower modifications ¡WARNINGS!  Read all inst

(FA F16 220G) (FA F16 220G) INSTALLATION MANUAL Follow these steps to ensure a simple installation of your new FASS ADJUSTA

220 GPH 8 PSI (Approximately) Adjustable Fuel Pump Series A fuel pressure gauge is highly recommended to identify fuel filter life and to prevent e

Contents FL-1002 x9’ WH-1002 BHB-1001 THB-1001 30 amp Fuse FF-3248 MP-9024 FPB-2005 PFB-2001C

*WE-1006* HC-1001 Ring Terminal BHF-1002 PL-1004 ST-1005Px16” BHN-1001 OR-223 LW-1001 RS-1002 Mounting Package Contents 1/2” Plug 10-300 PLB-1212

Factory Lift Pump WE-1006 C. Route wire harness along frame to the approximate mounting location near the fuel tank. Completion of this step will

D. With the fuel tank empty of fuel, remove it from the vehicle. E. Clean the fuel module area then remove the lock ring on the top of the fuel ta